Table of Contents
Advertisement
Fan Control
To start the fan. Press the selected speed button to run the fan at the desired speed.
LO=Low speed MED=Medium speed
To turn off the fan. Press the FAN OFF button.
Airflow Direction
To reverse the airflow press the REVERSE button. Reverse operates at any speed
whether fan is on or off. The fan returns to its set speed after reversing.
Light Control
Turn the light on or off independently from the fan by pressing the UP LIGHT DOWN
LIGHT OR BOTH button. (This is a rocker switch. Press the left side for the Up Light,
right side for the Down light , and themiddle for both.) Keep pressing the button in
excess of 0.7 seconds, it becomes a dimmer. The light varies from 'bright' to 'dim'
over approximately 8 seconds. This sequence will reverse the light when it reaches
the brightest or dimmest level if you continue to hold the LIGHT button. Release the
button when the desired level is reached.
Auto Resume
Quick (pressing less than 0.7 seconds) on/off operation of the LIGHT button main-
tains the desired brightness level set previously.
VERSA•TOUCH 2 © CHANGING FREQUENCY SETTING
Note: All fans leave the factory set to '00000'.
You will only have to change the dip switch settings in the remote
if you are using more than one fan in the same area and want to
control them separately.
Step 1. At the circuit breaker or fuse box, turn the power off for the
fan you want to change.
Step 2. Open the battery door of the Versa•Touch control and re-
move the batteries.
Step 3. Change the dip switch settings, assuring that they are dif-
ferent from the previously installed Versa•Touch fan.
Step 4. Re-install the batteries and the battery door on the con-
trol.
Step 5. At the circuit breaker or fuse box, turn the power back on
for the fan whose frequency you are changing.
Step 6. Within 20 seconds of restoring power, push the Hi, Med,
and Lo buttons (in that order).
Note: You may want to label your controls
to assure you do not mix them up.
WARNING: Do not turn the power off at the circuit
breaker, then back on, for the previously installed
Versa•Touch 2 fan(s), as you may inadvertantly change
the frequency settings for it as well.
VERSA•TOUCH 2 © IF FAN DOES NOT WORK
If the fan is not functioning after installation:
Step 1. Check to make sure that batteries are installed correctly
in the control.
Step 2. Turn the power off to the fan (from the circuit breaker)
for at least 5 seconds.
Step 3. Turn the power back on (at the circuit breaker) and
push the Hi, Med, and Low buttons–in that order–within 20
seconds.
Step 4. The fan should now function properly.
8
2
VERSA•TOUCH 2 OPERATION
HI=High speed
REVERSE
DIP SWITCH
SET TO '10000'
WITHIN 20 SECONDS OF
TURNING THE FAN ON,
PRESS IN THIS ORDER
TO SET NEW FRE-
QUENCY:
1. HI
2. MED
3
3. LO
PRESS IN THIS ORDER TO
SET NEW FREQUENCY:
CIRCUIT BREAKER
1. HI
OR FUSE BOX
LIGHT
MED
LO
FAN
OFF
VERSA•TOUCH
2
CONTROL
(BACK)
DIP SWITCH
SET TO '01001'
2
1
2
3
1
2. MED
3. LO
HI
Hide quick links:
Advertisement
Table of Contents
