Performing A System Reset From The Front Panel - Extron electronics DTP CrossPoint 4K Series User Manual

Performing a System Reset from the Front Panel

The front panel reset is identical to issuing the
reset (factory default)
functions:
• Clears all ties and presets
• Clears all mutes
• Enables all RS-232 pass-throughs
• Restores group masters 1 and 2 to their factory defaults (Mic volume and Volume)
NOTES:
•
System reset does not reset the Internet protocol (IP) settings or replace
user-installed firmware.
• This function resets only the switcher, not any connected DTP endpoints.
Reset the switcher to the factory default settings by pressing and holding the
and button simultaneously while you apply AC power to the switcher (see figure 34).
Esc
The switcher flashes
the button indicators
and then turns them off.
Figure 34.
NOTE: If background illumination was turned on before the reset, the I/O and control
buttons are unlit after the reset. When you cycle power, background illumination
returns to the condition that you previously selected.
SIS command on page 76). A system reset performs the following
Press and hold the buttons
simultaneously while you
apply power to the switcher.
CONTROL
VIEW ESC
Continue to hold the View and Esc
buttons until all input and output buttons
return to unlit and the Video and Audio
buttons light.
Release the buttons.
System Reset
DTP CrossPoint 4K Series Matrix Switchers • Operation
E }
SIS command (see the
ZQQQ
Power
System
button
View
50