Table of Contents
Advertisement
Selecting Lock mode 2 or toggling between mode 2 and mode 1
NOTE: If the switcher is in Lock mode 0 or mode 1, this procedure selects mode 2.
If the switcher is in Lock mode 2, this procedure selects mode 1.
Toggle the lock on and off by pressing and holding the Video button and the Audio button
simultaneously for approximately 2 seconds (see figure 25).
Lock mode 1
VIDEO
Press and hold for
2 seconds.
Figure 25.
Performing a System Reset from the Front Panel
The front panel reset is identical to issuing the
page 64. A system reset performs the following functions:
NOTES:
•
System reset does not reset the Internet protocol (IP) settings or replace
user-installed firmware.
•
This function resets not only the switcher, but any connected endpoints.
•
Clears all ties and presets
•
Clears all mutes
•
Disables all RS-232 output inserts
Restores group masters 1 and 2 to their factory defaults (Mic volume and Volume)
•
Reset the switcher to the factory default settings by pressing and holding the View button
and Esc button simultaneously while you apply AC power to the switcher (see figure 26).
The switcher flashes
the button indicators
and then turns them off.
Figure 26.
NOTE: If background illumination was turned on before the reset, the I/O and control
buttons are unlit after the reset. When you cycle power, background illumination
returns to the condition that you previously selected.
I/O
I/O
AUDIO
VIDEO
AUDIO
Toggle Front Panel Lock Between Mode 2 and Mode 1
Press and hold the buttons
simultaneously while you
apply power to the switcher.
CONTROL
ESC
VIEW
Continue to hold the View and Esc
buttons until all input and output buttons
return to unlit and the Video and Audio
buttons light.
Release the buttons.
System Reset
DTP CrossPoint 84 Series Matrix Switchers • Operation
Lock mode 0
I/O
CONTROL
VIDEO
AUDIO
ENTER
PRESET
Press and hold for
2 seconds.
E
}
SIS command defined on
ZXXX
Power
I/O
VIEW
ESC
VIDEO
AUDIO
44
Advertisement
Table of Contents
