Step 3: Applying Power - AMX NMX-MM-1000 Instruction Manual

Installation

Step 3: Applying Power

Applying power to the NMX-MM-1000 requires Cat5 cable and a PoE injector, such as the PS-POE-AF-TC available
from AMX, or a PoE-capable Ethernet switch. You must connect port 1 to your network through the PoE injector to
receive power to your NMX-MM-1000 device.
1.
Connect the PoE injector to an AC outlet (100-240VAC) using a standard power cord.
2.
Using Cat5 cable, connect your network switch to the Data In port on your PoE injector.
3.
Using a separate Cat5 cable, connect the Data & Power Out port on the PoE injector to LAN Port 1 on the
NMX-MM-1000.
FIG. 15 illustrates how to connect the PoE injector to the NMX-MM-1000.
Data & Power
Cat5 cable to Enzo
FIG. 15 PoE Injector connection
When power is applied, the POWER LED on the front panel appears red then blinks green while the device is booting.
When the device is finished booting and the device is ready for use, the LED remains solid green. The device usually
takes 20-30 seconds to boot. When booting is complete, the NMX-MM-1000 opens to the Enzo desktop (FIG. 16).
FIG. 16 Enzo desktop
10
Data In
Out
Cat5 cable from
your network
Instruction Manual - NMX-MM-1000 Enzo Meeting Presentation System