Shell Commands; Command Auto-Complete; Command Scopes - AMX NMX-MM-1000 Instruction Manual

Appendix A - AMX Shell Commands

Shell Commands

The following sections list the shell commands available for your Enzo device.

Command Auto-Complete

AMX Shell supports command auto-complete using the TAB key. You can press the tab key at the command prompt
anytime to see a listing of all available commands (FIG. 64).
> [TAB]
FIG. 64
Command list via Tab key
You can also press the tab key after entering one or more characters to see the listing of possible command matches
(FIG. 65).
> t [TAB]
FIG. 65 Command matching with the Tab key
If the auto-complete results find only a single match, the command is completed after the characters you enter (FIG. 66).
> to [TAB]
FIG. 66 Auto-complete using the Tab key

Command Scopes

AMX Shell registers all commands with a "scope" attribute. The scope is an additional qualifier that can help distinguish
duplicate command names at run/execution time. (Duplicate commands using the same command name and scope
names are not permitted.)
Note: It is best to avoid duplicate command names, but if necessary, you can use the scope to uniquely resolve each
distinct command.
The command scope is included in the command listing.
Note: Command names are also displayed without the scope identifier for commands that can be resolved without the
scope identifier.
You can use the scope name and press the TAB key to auto-complete and see the scope-specific command listing
(FIG. 67).
> enzo [TAB]
FIG. 67 Scope-specific command listing
62 Instruction Manual - NMX-MM-1000 Enzo Meeting Presentation System