Additional Documentation - AMX NMX-MM-1000 Instruction Manual

Updating Firmware


FIG. 61 Send to NetLinx Device dialog box (NetLinx Studio)
3.
Select the appropriate *.KIT file from the Files list.
4.
Enter the Device ID number of the Enzo in the Device text box and the System ID numbers for the Enzo in the
System text box. You can locate this information in the NetLinx settings in the System Settings. See the
NetLinx section on page 39 for more information.


5.
Review the File, Connection, Address, and Target Device information before you send.
6.
Click the Send button. You can watch the progress of the transfer in the Send to NetLinx Device dialog box.
NetLinx Studio transfers the files to the Enzo and then tells it to reboot. After it reboots, the Enzo actually goes through
the upgrade process.
Note: Upgrading the device firmware can take several minutes.
WARNING! If for any reason your Kit file transfer should fail, continue to retry the transfer until you are successful. DO
NOT reboot the Enzo, or change connections until the transfer is complete. Failure to complete this operation
successfully may require a factory repair of the Enzo.

Additional Documentation

For additional information on using NetLinx Studio, refer to the NetLinx Studio online help and
Operation/Reference Guide (available at www.amx.com).
48
The selected directory path is displayed in the Send To NetLinx Device dialog (Location text box).
Assuming that the specified target directory contains one or more KIT files, the KIT files in the selected
directory are displayed in the Files list box, with the file's last modified date and time (FIG. 61).
The device number of the NetLinx Master is 0.
Use the Online Device Tree to determine the device's assigned IDs, if it has been changed.
Instruction Manual - NMX-MM-1000 Enzo Meeting Presentation System