Mounting On A Surface - AMX NMX-MM-1000 Instruction Manual

Overview

Mounting on a Surface

Perform these steps to mount the Enzo on a surface:
Note: The #8 x 1/2 inch tapping pan head screws provided for mounting to a flat surface are designed for wood. If the
module needs to be mounted on a different type of surface, use the appropriate type of fastener, e.g., dry wall anchors
(not provided).
1.
Place the NMX-MM-1000 in the desired final position on the mounting surface and mark the screw position as
indicated in FIG. 5.
FIG. 5 Mark screw positions
Important: The mark for the screw's position in each of the mounting holes needs to be made in the end of the slots (all
marks to either the top of the slots or all marks to the bottom).
2.
Set the device aside. If using the wood screws provided, drill pilot holes (drill size 29; hole diameter 0.136 in.) for
the screws 1/2 inch (1.27 cm) deep. Insert the screws in the holes, but do not tighten them completely.
FIG. 6 Drill pilot holes and insert screws, but do not tighten
3.
Align the module with the center of the double key-hole slots over the screws and slide into place as indicated in
FIG. 7.
FIG. 7 Align device over screws and slide into place
4.
Tighten the screws.
4 Instruction Manual - NMX-MM-1000 Enzo Meeting Presentation System