HDMI OUT
The rear panel features one HDMI connector for video output.
The following table describes the pinout configuration of the HDMI OUT connector:
HDMI OUT Connector - Pinouts and Signals
Pin
Signal
1
TMDS Data 2+
2
TMDS Data 2 Shield
3
TMDS Data 2-
4
TMDS Data 1+
5
TMDS Data 1 Shield
6
TMDS Data 1-
7
TMDS Data 0+
8
TMDS Data 0 Shield
9
TMDS Data 0-
10
TMDS Clock+
FIG. 12 displays the pin locations for the HDMI connector:
FIG. 12
HDMI pinouts
AUDIO OUT
The rear panel features one 3.5mm mini-phono connector for audio output.
RS-232
The rear panel features one 9-pin DB9 connector for RS-232 ports.
Note: Use of the RS-232 port is NOT supported in the current Enzo firmware release. A future release will enable use of
this port to control displays.
FIG. 13 provides wiring specifications for the RS-232 connector.
1 2 3 4 5
FIG. 13
RS-232 (DB9 - male) connector pinouts
The RS-232 port supports the following data rates and formats:
Instruction Manual - NMX-MM-1000 Enzo Meeting Presentation System
RS-232 pinouts (male connector)
Pin 2: RX signal
Pin 3: TX signal
Pin 5: GND
Pin 7: RTS
6 7 8 9
Pin 8: CTS
Baud rate: 150-115200
Parity: None, Odd, Even, Mark, Space
Data Bits: 7 or 8
Stop Bits: 1 or 2
Software handshaking with XON & XOFF: On or Off
Pin
Signal
11
TMDS Clock Shield
12
TMDS Clock-
13
CEC
14
Reserved, HEC Data
15
SCL
16
SDA
17
DDC/CEC/HEC Ground
18
+5V Power (max 50mA)
19
Hot Plug Detect, HEC Data+
Wiring and Device Connections
7