Chapter 3. Terminal Menu Operation
WAN IP Bridge/Proxy ARP
If this option is set to Yes (def), the Express L128T S/T will proxy ARP
on the bridge IP port. See the section IP/Proxy ARP on page 3-19 for an
explanation of the proxy ARP function.
Bridge/WAN IPX Bridge
When IPX routing is active, the Express L128T S/T will allow another
WAN device to bridge IPX packets to it using PPP BCP. Normally,
two IPX routers would negotiate PPP IPXCP to exchange IPX packets.
However, if a device can only support PPP BCP, IPX packets are en-
capsulated by the device as bridge packets. The Express L128T S/T
can treat the WAN IPX Bridge as a virtual Ethernet port connected
only to a WAN device which has negotiated PPP BCP. This menu al-
lows the IPX parameters for this virtual Ethernet to be setup.
WAN IPX Bridge/Network
Write security: 2; Read security: 5
This is the network address of the virtual Ethernet port. See IPX/Net-
work on page 3-21 for an explanation of the IPX network number.
WAN IPX Bridge/Frame Type
Write security: 2; Read security: 5
This is the frame type used for the virtual Ethernet port. See IPX/
Frame Type on page 3-21 for an explanation of the IPX frame type.
WAN IPX Bridge/Seed Status
Write security: 2; Read security: 5
This is the seed status used for the virtual Ethernet port. See IPX/Seed
Status on page 3-22 menu for an explanation of the IPX seed status.
61202070L3-20
Express L128T S/T User Manual
3-25