Security/Filter Defines; Filter Defines /Mac Filter Defines - ADTRAN Express L128T S User Manual

The following selections are possible:
PAP, CHAP,
or EAP (def)
CHAP or EAP The Express L128T S/T will ask for EAP during the first
EAP

Security/Filter Defines

The Express L128T S/T can filter packets based on certain parameters
within the packet. The method used by the Express L128T S/T allows
the highest flexibility for defining filters and assigning them to a Con-
nection List profile. The filters are set up in two steps: (1) defining the
packet types, and (2) adding them to a list under the Connection List
profile. See the section Connection List/Filters on page 3-55 for exam-
ples of how to set up filter profiles. This menu is used to define the
individual filter defines based on packet type.

Filter Defines /MAC Filter Defines

Write security: 2; Read security: 3
The MAC filter is applied to bridge packets only. Bridge packets
which are forwarded by the bridge functionality of the Express L128T
S/T are defined here. Up to 32 MAC defines can be specified.
Name
Src Addr
Src Mask
Dest Addr
Dest Mask
MAC Type
Type Msk
61202070L3-20
The Express L128T S/T will ask for EAP during the first
PPP LCP negotiation and allow the PPP peer to
negotiate down to CHAP or PAP.
PPP LCP negotiation and allow the PPP peer to
negotiate down to CHAP but not PAP.
The Express L128T S/T will only allow EAP to be
negotiated. If the PPP peer is not capable of doing
EAP, then the connection will not succeed.
Identifies the filter entry
48-bit MAC source address used for comparison.
(hexadecimal format)
Bits in the MAC source address which are compared.
(hexadecimal format)
48-bit MAC destination address used for comparison.
(hexadecimal format)
Bits in the MAC destination address used for
comparison. (hexadecimal format)
16-bit MAC type field used for comparison.
(hexadecimal format)
Bits in the MAC type field used for comparison.
(hexadecimal format)
Express L128T S/T User Manual
Chapter 3. Terminal Menu Operation
3-33