Bridge/Mode; Bridge/Wan Ip Bridge; Wan Ip Bridge/Network; Wan Ip Bridge/Netmask - ADTRAN Express L128T S User Manual

Chapter 3. Terminal Menu Operation

Bridge/Mode

Write security: 2; Read security: 5
When this option is set to On (def), the Express L128T S/T bridge
function is enabled. Setting it to Off disables all bridge functionality.

Bridge/WAN IP Bridge

When IP routing is active, the Express L128T S/T allows another
WAN device to bridge IP packets to it using PPP BCP. Normally, two
IP routers would negotiate PPP IPCP to exchange IP packets. Howev-
er, if a device can only support PPP BCP, IP packets are encapsulated
by the device as bridge packets. The Express L128T S/T can treat the
WAN IP Bridge as a virtual Ethernet port connected only to a WAN
device which has negotiated PPP BCP. This menu allows the IP pa-
rameters for this virtual Ethernet to be set up.

WAN IP Bridge/Network

Write security: 2; Read security: 5
This is the IP address of the virtual Ethernet port.

WAN IP Bridge/Netmask

Write security: 2; Read security: 5
This is the network mask to be applied to the virtual Ethernet port.

WAN IP Bridge/Triggered

Write security: 2; Read security: 5
When set to Yes, only IP RIP updates are sent when the routing table
has changed. When set to No (def), updates are sent periodically. RIP
version, method, and direction are determined by the Ethernet pa-
rameters set in the Configuration/IP/IP Router/RIP menu.
3-24 Express L128T S/T User Manual 61202070L3-20