Phone Controls; Labeling Softkey Functions; Display The Date And Time; Call Timer - Avaya 9040 User Manual

Phone Controls

Phone Controls

Labeling Softkey Functions

Display the Date and Time

Call Timer

4400, 4600, 6400 & TransTalk MDW 9040 Telephones
IP Office
You can rename the softkey functions that appear when you press Menu
. Note that this doesn't affect the function names shown when you
select Prog or Admin.
4406D+, 4606D+ and TransTalk
this feature.
To relabel softkey functions:
1. Press Menu .
2. Using the and keys, display and then select Prog (This feature can
also be set under a DSS key, see page 24).
3. Use the and keys to display and select the function to relabel.
4. Press Label.
5. Use the dialing keys and Rotat to enter characters, e.g. to enter an L
press the 5 key and then press Rotat until an L is displayed.
6. When the label is as you require press Done.
You can change your phone display to show the date and time. This uses
the TmDay function. Note that this function overwrites all other display
information.
®
TransTalk MDW 9040 users do not have access to this feature.
To set/cancel date and time display:
1. Press Menu .
2. Using the and keys, display and select TmDay (This feature can
also be set under a DSS key, see page 24).
You can run a call timer. If you start the timer before making a call, it will
reset to zero when you dial and again when you are connected.
Note that after ending a caller the timer is switched off.
®
TransTalk MDW 9040 users do not have access to this feature.
To start the call timer:
1. Press Menu .
2. Select Timer (This feature can also be set under a DSS key, see page
24).
®
MDW 9040 users do not have access to
40DHB0002USAL - Issue 7 (2nd October 2003)
Page 19
Page 19