Front And Rear Panel Controls And Connectors; Introduction; Front Panel Controls And Indicators - TDK-Lambda GENESYS 750W User Manual

4

FRONT AND REAR PANEL CONTROLS AND CONNECTORS

4.1

Introduction

The Genesys
that allow the user to easily setup and operate the unit. Before starting to operate the unit,
please read the following Sections for explanation of the functions of the controls and
connectors terminals.

Section 4.2: Front Panel Controls and Indicators.

Section 4.3: Rear Panel Connections and Controls.
4.2

Front Panel Controls and Indicators

See Fig.4-1 to review the controls, indicators and meters located on the power supply front
panel.
POWER
19
Table 4-1: Front Panel controls and indicators
Number Control/Indicator
1 VOLTAGE control
2 VOLTAGE indicator
3 VOLTAGE display
TM
Power Supply series has a full set of controls, indicators and connectors
2
1
VOLTAGE
DC VOLTS
ALARM FINE
16
18
15
17
Fig.4-1: Front panel controls and indicators
Description
High resolution rotary encoder for adjusting the Output Voltage.
Also adjusts the OVP/UVL levels and selects the Address
Green LED, lights for constant-Voltage mode operation.
4 digit, 7-segment LED display. Normally displays the Output
Voltage. When the PREV button is pressed, the display indicates
the programmed setting of the Output Voltage. When the
OVP/UVL button is pressed, the Voltage display indicates the
OVP/UVL setting.
83507013 Rev G
3
4
OVP
PREV/ UVL FOLD REM/LOC OUT
14 11
13 9
12
49
6
5
CURRENT
DC AMPS
7
8
10
Section
5.2.1
5.3.1
5.4.1
7.2.2