Emerson VININGS CF240ATB00 Owner's Manual page 8

BP7359 VININGS CF240 9/19/07
12. Unscrew the two upper setscrews
(Figure 8) until they clear the inside of
the motor coupling. Then separate,
untwist and unkink the three 80"
motor leads. Route the motor lead
wires through the downrod. Align the
clevis pin holes in the downrod with
the holes in the motor coupling. Install
the clevis pin and secure with the
hairpin clip (Figure 8). The clevis pin
must go through the holes in the
motor coupling and the holes in the
downrod. Be sure to push the straight
leg of the hairpin clip through the hole
near the end of the clevis pin until the
curved portion of the hairpin clip
snaps around the clevis pin. The
hairpin clip must be properly installed
to prevent the clevis pin from working
loose. Pull up on the downrod to
make sure the clevis pin is properly
installed.
WARNING
!
It is critical that the clevis pin in the motor
coupling is properly installed and the
setscrew securely tightened. Failure to
verify that the pin and setscrew are
properly installed (as shown in Figure 8)
could result in the fan falling.
DOWNROD
HAIRPIN
CLIP MOTOR
COUPLING
Figure 8
11:13 AM Page 8
13. Tighten the two upper setscrews
(Figure 8) securely while pulling up on
the downrod.
NOTE: The setscrews must be properly
installed as described above, or fan
wobble could result.
14. Position the three scrolls on the
decorative coupling cover so that they
are vertical, then tighten the nuts on
the inside of the coupling cover. Make
sure the grommet is properly installed
in the decorative coupling cover, then
slide the coupling cover over the
downrod until it rests on the motor
housing (Figure 9).
NOTE: If you installed the 8" downrod,
the decorative downrod scroll will not
be installed. Disregard step 15 and
proceed to step 16.
DECORATIVE
DOWNROD
SCROLL
COLLAR
CLEVIS
PIN
MOTOR
HOUSING
Figure 9
SETSCREW (2)
15. Using the hex wrench (supplied),
unscrew
decorative downrod scroll collar until
it clears the inside of the collar. Slide
the collar over the downrod (Figure
9), until it rests on the coupling cover,
then tighten the setscrew.
8
SETSCREW
SCROLL (3)
DECORATIVE
COUPLING
COVER
the setscrew in the
U.L. Model No.: CF240