Summary of Contents for Emerson Botanica CF2500HTW01
Page 1
READ AND SAVE THESE INSTRUCTIONS CF2500OB01 CF2500S01 Botanica Series Ceiling Fan Owner's Manual Part No. F40BP72200003 “Botanica” Series Model No. CF2500HTW01 CF2500TG01 20.0 Net Weight: ® Form No. BP7220-3...
6. Follow the recommended instructions for the proper method of wiring your ceiling fan. If you do not know enough about electrical wiring, have your fan installed by a licensed electrician. WARNING: To avoid fire, shock or injury, do not use an Emerson or any other brand of control not specifically approved for this fan.
Emerson. Substitution of parts or accessories not designated for use with this product by Emerson could result in personal injury or property damage. 1. Open styrofoam unit containing fan. Remove top half of styrofoam unit.
Any electrical work not described in these instructions should be done or approved by a licensed electrician. The Emerson CF2500 Ceiling Fan is designed to be operated from a SR330 Remote Control, from a SW350 Wall Control with a SW375 Receiver, or from other fan/light controls.
Page 5
5. Using wiring connectors (supplied), connect the white, red, blue, brown, and yellow wires from the downrod to the white, red, blue, brown and yellow wires of the ceiling fan (Figure 4). Wires must be connected color-to-color. SW375 RECEIVER BLACK WIRE...
Page 6
Failure to verify that the pin and setscrew are properly installed could result in the fan falling. 11. Reinstall the hanger ball on the downrod as follows. Route the motor leads through the hanger ball and slide the hanger ball over the downrod (Figure 7).
Page 7
WARNING The fan must be hung with at least 7' of clearance from floor to blades (Figure 12). CEILING AT LEAST FLOOR Figure 12 WARNING The outlet box must be securely anchored and capable of withstanding a load of at least 50 lbs.
Page 8
Remove the backing on the foam adhesive pads and press the receiver against the ceiling. 25. To complete the ceiling fan assembly, skip to the “FINAL ASSEMBLY” section of this Owner’s Manual. SECTION B...
Page 9
Cut off excess leads and strip back insulation 1/2-inch from end of leads. NOTE: If you are installing your fan with a SR330 Remote Control or SW350 Wall Control, Do Not Cut Terminal Off of the Yellow Lead.
Page 10
SWITCH HOUSING CONNECTOR COLLAR SETSCREW Figure 25 WARNING The fan must be hung with at least 7' of clearance from floor to blades (Figure 26). AT LEAST Figure 26 SETSCREW The outlet box must be securely anchored and capable of withstanding a load of at least 50 lbs.
Refer to the installation instructions and wiring diagrams supplied with the Emerson Fan Control Owner’s Manual. a. Connect the green grounding lead from the hanger ball and the green grounding lead from...
The fan blades will turn in the opposite direction and reverse the airflow. Attaching Light Kit To install an Emerson accessory light kit, remove the four screws securing the switch housing cover assembly to the switch housing. Remove the trim medallion from the bottom of the switch housing cover (Figure 32).
6. Fan blades out of balance. IMPORTANT CARE INSTRUCTIONS for your Ceiling Fan Periodic cleaning of your new ceiling fan is the only maintenance that is needed. When cleaning, use only a soft brush or lint free cloth to avoid scratching the finish.
Emerson. Substitution of parts or accessories not designated for use with this product by Emerson could result in personal injury or property damage. ACCESSORIES 1. Ceiling Fan Light Kits (see store or catalog).
You will be responsible for all insurance, freight or other transportation charges to our factory or authorized service center. Your Emerson Air Comfort Ceiling Fan should be properly packed to avoid damage in transit since we will not be responsible for any such damage.