Emerson VININGS CF240ATB00 Owner's Manual page 6

BP7359 VININGS CF240 9/19/07
Figure 1
2. Remove and discard the four shipping
retainers securing the motor hub in the
motor housing.
NOTE: Take care not to scratch the fan
housing when installing the blade
assemblies.
3. Position the blade flange on the motor
hub so that the mounting holes in the
blades flange align with the two
threaded holes in the motor hub (Figure
2). Securely install two 1/4-20 x 13mm
oval head screws (supplied). Repeat
this procedure for the remaining four
blade assemblies.
REMOVE AND RETAIN ONE PAN HEAD
SCREW/LOCKWASHER; LOOSEN TWO PAN
HEAD SCREWS
MOTOR
FLANGE
Figure 2
11:13 AM Page 6
4. Remove and retain one of the three
10-24 x 8mm
TRUSS HEAD
pan head screw/lockwashers from the
SCREWS (3)
motor flange (Figure 2); loosen the
FLAT
other two pan head screws three or
WASHERS (3)
four turns.
5. Position the light fitter adapter on the
motor flange so that the two screws
FAN BLADE
mate with the two keyhole slots in the
light fitter adapter (Figure 3).
NOTE: Make sure that the lockwashers
are positioned between the screw head
and the light fitter adapter.
REINSTALL ONE PAN HEAD
BLADE FLANGE
SCREW/LOCKWASHER
LIGHT FITTER
ADAPTER
Figure 3
6. Turn the light fitter adapter clockwise
and tighten both screws (Figure 3).
Reinstall
screw/lockwasher (previously remov-
ed) in the remaining hole in the light
fitter adapter.
1/4-20 x 13mm OVAL
7. Carefully rest the light fitter assembly
HEAD SCREWS (2)
on the adapter, then engage the light
BLADE
fitter
FLANGE
connector
connectors are keyed and color-coded
and must be mated correctly (color-to-
color) before they can be engaged.
Make sure the connectors are engaged
properly.
MOTOR HUB
6
TIGHTEN TWO PAN
HEAD SCREWS
the other pan
connector with the motor
(Figure 4). The
U.L. Model No.: CF240
head
two