Emerson VININGS CF240ATB00 Owner's Manual page 13

BP7359 VININGS CF240 9/19/07
40-WATT (MAX.)
CANDELABRA
BULBS (3)
THREADED
NIPPLE
LOWER
GLASS
METAL
WASHER
Figure 17
Setting Operating
Frequency of Wall
Control and Receiver
(Figure 18)
Your wall control and receiver have code
switches which must be set in one of 16
possible code combinations. The four
levers (numbered 1, 2, 3, and 4) on the
switches are factory-set in the ON (up)
position. Change the switch settings as
follows:
1. Slide the four switch levers in the wall
control to your choice of ON (up) or
down positions. Use a ball-point pen or
small screwdriver and slide the levers
firmly up or down.
2. In the receiver, slide the four switch
levers to the same positions as set in
the wall control. Make sure the levers
on both switches are in the same
positions, otherwise the fan will not
operate.
11:13 AM Page 13
ANTENNA WIRE
REVERSING
SWITCH
LIGHT
RECEIVER
FITTER
RECEIVER
SWITCH LEVERS
1 2 3 4
ON
WALL
CONTROL
RUBBER
WASHER
1/8 x 24 NUT
Figure 18
DECORATIVE
CAP
Installation of Wall
FINIAL NUT
SINGLE-POLE INSTALLATION
(Figure 19)
HOT BLK
NEUTRAL
REMOTE CONTROL
RECEIVER LOCATED
WITHIN THE CEILING
COVER
Figure 19
1. Disconnect power at circuit breaker or
remove fuse.
2. Remove faceplate and screws from
existing wall control. Pull control out
from the wall box. Determine the "hot"
wire and the "load" wire and disconnect
these wires from control. Do not
attempt to disconnect any wires not
already connected to existing control.
3. Before installing wall control, place wall
control in "OFF" mode by pushing
"ON/OFF" switch to the "OFF" position.
13
ON
CODE
WALL CONTROL
LEVERS
SWITCH
CODE
SWITCH
Control
FAN/LIGHT
WALL CONTROL
HI
LIGHT
MED
LOW
BLACK
FAN OFF
®
EMERSON
OFF ON
GROUND
U.L. Model No.: CF240