Emerson VININGS CF240ATB00 Owner's Manual page 7

BP7359 VININGS CF240 9/19/07
LIGHT FITTER
ASSEMBLY
REMOVE AND RETAIN
THREE PAN HEAD
SCREW/LOCKWASHERS
Figure 4
8. Remove and retain the three outer
screw/lockwashers from the light fitter
adapter (Figure 4).
9. Position the light fitter assembly on the
light fitter adapter. Line up the three
holes on the light fitter with the
threaded holes in the adapter and
reinstall three screw/lockwashers
(previously removed) (Figure 5).
CAUTION: Before
tightening the screws, be sure there are
no wires pinched between the light
fitter and the light fitter adapter.
REINSTALL THREE
PAN HEAD SCREW/
LOCKWASHERS
LIGHT FITTER
ADAPTER
Figure 5
11:13 AM Page 7
10. Position the top and bottom halves of
the styrofoam packaging side-by-side
on the floor with a six to eight inch gap
LIGHT FITTER
CONNECTOR
between the halves (Figure 6).
Carefully place the partially assembl-
ed ceiling fan on the styrofoam
halves, with the light fitter assembly
positioned in the gap and the fan
assembly resting on the fan blade
MOTOR
assemblies.
CONNECTOR
PARTIALLY
ASSEMBLED FAN
Figure 6
installing and
11. Remove the hanger ball by loosening
the setscrew in the hanger ball until
the ball falls freely down the downrod
(Figure 7). Remove the pin from the
downrod, then remove the hanger
ball. Retain the pin and hanger ball for
LIGHT FITTER
reinstallation in step 16.
ASSEMBLY
PIN
HANGER
BALL
DOWNROD
Figure 7
NOTE: If you have an eight-foot ceiling,
you will have to use the 8" downrod
(supplied) in order to maintain the
necessary blade-to-floor clearance of
seven feet.
7
6 TO
8-INCH
GAP
STYROFOAM PACKAGING
SETSCREW
U.L. Model No.: CF240