Compuprint 914 User Manual page 96

Appendix A
ESC / {m}
The {m} parameter specifies the VFU channel number.
VT
In IBM mode, this code will be executed like a LF code, if the tab stop follows the
bottom of form position or if the current position is beyond the last tab stop or if
no tab stop has been sent by the ESC B. In EPSON mode, the vertical tabulations
that should be executed are referred to the VFU channel selected by the ESC / {m}
command. If no VFU channels have been selected, the printer assumes as default
the channel 0. This code will be executed like a FF code if the tab stop follows the
bottom of form position or if the current position is beyond the last tab stop. It will
be executed like a LF code, if no tab stop has been set.If the vertical tabulations
have been reset , the LF will be not executed.
ESC b {m} NUL
The {m} parameter specifies the VFU channel number.
ESC R
This command sets horizontal tab stops every eight colums starting from column
9, and cancels all vertical tab stops.
A.12
Select the Vertical Format Unit (VFU) channel (only
EPSON mode)
1B 2F {m}.
27 47 {m}
0≤ m ≤ 7
Advances paper to the next vertical tap stop of the
selected VFU channel.
0B
11
Cancels all current vertical tab stops set in the
specific VFU channel (only EPSON mode).
1B 62 {m} 00
27 98 {m} 0
0 ≤ m ≤ 7
Sets horizontal and vertical tab stops to default
values (only IBM mode).
1B 52
27 82
A78401745-001