Compuprint 914 User Manual page 119

ESC e {n} {m}
This command causes the print head to be moved to a dot position calculated as
{n+m*256}/120 inch on the left of its current dot position. If the selected position
is outside the current left margin, it is forced to first column.
ESC [ \ {l} {h} {m1}...{m4}
This command sets the value of the vertical units. {h}*256+{l} is the number of
bytes for this command. You can set the vertical units to 1/180 inch or 1/216 inch
according to the following table:
m3
0
180
m3
0
216
ESC j
Terminator code. It then causes the printing to be stopped and the buzzer to be so
unded. The printer will be disabled to print, press the
printer online. This command has the same effect by pressing the
key.
Spaces backwards relative dot position (only IBM
mode).
1B 65 {n} {m}
27 101 {n} {m}
0 ≤ n, m ≤ 255
Sets vertical units (only IBM mode).
1B 5B 5C {l} {h} {m1}...{m4} m1 = ignored
27 91 92 {l} {h} {m1}...{m4} m2 = ignored
l = 4 m3 = normally equal to 180
h = 0 m4 = normally equal to 216
m4
180
0
m4
216
0
Stops printing (only IBM mode).
1B 6A
27 106
A78401745-001
Appendix A
Vertical Units
1/180 inch
1/180 inch
Vertical Units
1/216 inch
1/216 inch
/← key to put
ON LINE
ON LINE
/←
A.35