Compuprint 914 User Manual page 116

Appendix A
{n1} and{n2}
The {n1} and{n2} parameters specify the number of bytes in the escape
sequence normally,
n1
n2
{init}
The {init} parameter specifies to which condition the printer should initialize,
normally {init} = 0,1,4, 5, 254 and 255.The first four values definitions affect the
mode settings (i.e. quality, pitch or print mode) that can be selected via operator
panel if no parameters are specified, however if the 0,1,or 256 values and the
parameter(s) are specified, these ones overwrite the user function selection.
init Description
0 Printer initialized to user default setting. Download font is not cleared
1 Printer initialized to user default setting. Download font is cleared
4 Printer initialized to factory default setting.Download font is not cleared
FE Printer performs as value 1.Initialization results are saved and become
the user default setting
FF Printer performs as value 1.Initialization results are saved and become
the user default setting
{id}
The {id} parameter specifies the printer for which the following parameter
bytes are intended. If the ID does not address your printer , the mode bytes that
follow are ignored.
{parm1}
The {parm1} parameter specifies which printer function is enable (on) or
disable (off). These are the value definitions
Bit
7 Discard byte
6 Reserved
5 Alarm enable
4 Auto CR
A.32
1,3 or 4
Always 0
OFF
Process this byte
Enable
No CR on vertical movement
A78401745-001
ON
Ignore this byte
Disable
CR on vertical movement