Buzzer - Compuprint 914 User Manual

Normal Mode
Setup Mode

Buzzer

This printer is provided with a buzzer to indicate specific conditions. The
buzzer signal changes according to the error detected. The buzzer only sounds
when the BUZZER function is set to ON (see "The Printer Setup" described
before). See the following table:
Sound
1 short "beep"
4 melody "beeps"
Twice 2 short "beeps"
3 long "beeps"
3 short "beeps"
Pressing this key selects the font.
Invalid
A BELL command is received
A paper empty error condition
The friction release lever is moved while
the paper is loaded in the printer
The single sheets cannot be ejected
The carrier cover is open
A78401745-001
Chapter 3
Cause
3.9