Loading Envelopes (Friction Feed Mode) - Compuprint 914 User Manual

Chapter 3
Before loading the crimped form (If the crimped form is not correctly loaded,
a paper jam may occur), check the correct direction of the form

Loading Envelopes (Friction Feed Mode)

The envelopes must be only inserted from the top of the printer (Top insertion).
Select the suitable gap set lever position according to the thickness of the
envelope to be loaded (i.e., if the thickness of the envelope is 0.35 mm (0.014
inches), set the gap set lever to Position 5 or 6.). To load the envelopes, proceed
as follows:
1.
Move the friction release lever to the
Tractor position. Make sure that the
paper stand is installed on the printer.
2.
Insert the envelope, aligning the left edge
of the paper to the sheet guide, Move the
friction release lever to the Friction
position.
3.32
Tractor
A78401745-001