Paradyne 7610 SNMP DSU User Manual page 98

7610-A2-GB20-10
Table C-2. Interfaces Group Objects (2 of 4)
Object Description
ifType Identifies the interface
( ifEntry 3 ) type based on the
physical/link
protocol(s), right below
the network layer.
ifMtu Identifies the largest
( ifEntry 4 ) datagram that can be
sent or received on an
interface (Management
port or IMC).
ifSpeed Provides the current
( ifEntry 5 ) bandwidth for the
interface in bits per
second.
ifAdminStatus Provides interface
( ifEntry 7 )
status. Supported as
read-only.
November 1997
Setting/Contents
Supported values:
other( 1 ) – Used for the DDS network.
ppp( 23 ) – Used for the In-band
Management Channel and for the
Management port, when configured for
PPP.
slip( 28 ) – Used for Management port,
when configured for SLIP.
rs232( 33 ) – Used for the Terminal port
and the Management port, when not
configured as Net Link.
v35( 45 ) – Used for the User Data port.
Number of octets.
Management port – Configured data rate
for the port.
Terminal port – Configured data rate for
the port.
DDS – Line rate of 56,000 or 64,000 bps,
reflecting the line rate detected by the unit.
User data (DTE) port – Current data rate of
the port (DDS operating rate minus IMC
rate).
In-band Management Channel –
Configured data rate for the In-band
Management Channel.
up(1) – The interface is enabled.
down(2) – The interface is disabled.
MIB Descriptions
C-5