Paradyne 7610 SNMP DSU User Manual page 108

Synchronous Port Table Objects
The Synchronous Port Table Objects contains an entry for the synchronous user
data port and the Management port when this port is configured for synchronous
operation. For this unit, entries in the table that are counters (rs232SyncPortEntry
3–7) are used to collect statistics only and are not supported. Clarification for
objects contained in this table as it applies to the unit is provided below.
7610-A2-GB20-10
Table C-9. Asynchronous Port Table Objects (2 of 2)
Object Description
rs232AsyncPort Specifies the type of parity
Parity used by the port.
(rs232Async
PortEntry 4 )
rs232AsyncPort Specifies the ability to
AutoBaud automatically sense the
(rs232Async input speed of the port.
PortEntry 5 )
Table C-10. Synchronous Port Table Objects (1 of 2)
Object Description
rs232SyncPort Specifies the clock source
ClockSource for the port.
(rs232Sync
PortEntry 2 )
rs232SyncPort Specifies whether this
Role device interface is a DTE or
(rs232Sync
DCE.
PortEntry 8 )
rs232SyncPort Specifies the bit encoding
Encoding technique that this port
(rs232Sync uses.
PortEntry 9 )
rs232SyncPort Specifies the method used
RTSControl to control the RTS signal.
(rs232Sync Refer to Data Port Options,
PortEntry 10 ) Table A-3.
November 1997
MIB Descriptions
Setting/Contents
Supports only the following values:
none(1) – No parity bit
odd(2) – Odd parity
even(3) – Even parity
Supports only the following values:
disabled(2) – Does not support
Autobaud.
Setting/Contents
Supports only the following values:
internal(1) – The port uses an internal
clock.
split(3) – The port uses an external
transmit clock and internal receive clock.
Supports only the following value:
dce(2) – The port acts as a DCE.
Supports only the following value:
nrz(1) – The port uses non-return to
zero encoding.
Supports only the following values:
controlled(1) – For User Data port, this
value is used when the Data Port option
Carrier Control by RTS is set to
Switched.
constant(2) – For User Data port, this
value is used when the Data Port option
Carrier Control by RTS is set to
Constant. This is the only valid value for
the Management port.
C-15