Paradyne 7610 SNMP DSU User Manual page 91

Worksheets
B-2
Network Interface
Configuration Option
Network-initiated DSU Loopback (64K CC)
Data Scrambling (64K CC)
V.54 Initiated DSU Loopback
In-Band Management Channel Rate (bps)
IMC IP Address
IMC Subnet Mask
IMC Routing Information Protocol
Cross Pair Detection Alarm
No Signal Alarm
Out of Service Alarm
Out of Frame Alarm
Excessive BPV Alarm
In-Band Framing Alarm
Data Port
Configuration Option
Invert Transmit Clock
Port (DTE) Initiated Loopbacks
Bilateral Loopback
Carrier Control by RTS
CTS Control
RLSD Control
DSR Control
Monitor DTR
November 1997
Settings
[Enable], Disable
Enable, [Disable]
Enable, [Disable]
[Disable], 1600, 4000, 8000
[000.000.000.000] – 223.255.255.255
[000.000.000.000] – 255.255.255.255
None, [Proprietary]
[Enable], Disable
[Enable], Disable
[Enable], Disable
[Enable], Disable
[Enable], Disable
[Enable], Disable
Settings
Enable, [Disable]
[Disable], Local, Remote, Both
Enable, [Disable]
[Constant], Switched
[Standard], Follow RTS, Forced On,
Circuit Assurance
[Standard], Forced On
[Standard], Forced On, On During Test
[Enable], Disable
7610-A2-GB20-10
Default in [Bold]
Default in [Bold]