A2-Gb20 - Paradyne 7610 SNMP DSU User Manual

Standards Compliance for SNMP Traps
D-4
The tests that affect the enterpriseTestStart, enterpriseTestStop, and the
variable-binding are different for each particular interface. Diagnostic tests are
only supported on the physical DDS network and user data port interfaces. The
specific tests and variable-bindings are described in the following table:
enterpriseTestStart/Stop
Interface
Variable-Bindings
Physical Sublayer
DDS network
Synchronous User
Data Ports
November 1997
ifIndex (RFC 1573)
ifAdminStatus
(RFC 1573)
ifOperStatus (RFC 1573)
i
fType (RFC 1573)
ddsTestType (DDS
Enterprise MIB)
ifIndex (RFC 1573)
ifAdminStatus
(RFC 1573)
ifOperStatus (RFC 1573)
i
fType (RFC 1573)
ifTestType (RFC 1573)
Possible Cause
enterpriseTest Start – Any one
of the following tests is active
on the interface:
– DSU Loopback
– CSU Loopback
– Send 511 pattern
– Monitor 511 pattern
enterpriseTest Stop – No
longer has any tests running
on the interface.
enterpriseTest Start – Any one
of the following tests is active
on the port:
– Local Loopback (DTE)
– Send 511 pattern
– Monitor 511 pattern
enterpriseTest Stop – No
longer has any tests running
on the port.

7610-A2-GB20-10