Beeper Indications; Beeper Indications During Normal Operation; Beeper Indications During Configuration - Allen-Bradley 2-D User Manual

3–8

Beeper Indications

When scanning a bar code symbol, listen for a single, short beep
from the scanner. This beep indicates a successful decode. Refer to
the tables below for all other responses.

Beeper Indications During Normal Operation

This Response
1 Beep (short high tone)
1 Beep (long high tone)
3 Beeps (short high tone)
4 Beep (high/high/high/high tone)

Beeper Indications During Configuration

This Response
1 Beep (short high tone)
1 Beep (high / low / high / low tone)
2 Beeps (low / high tone)
Publication 2755-6.4
Operating the Scanner
Indicates
Bar code symbol decoded. Beeper Tone
must be enabled.
Thermal shutdown.
Power-on or reset. Occurs immediately after
the scanner is turned on, indicating the
system software is working properly. If 3
beeps occur during normal operation, it is due
to a reset; any work in progress is lost. If this
occurs, contact your Allen-Bradley
representative.
Low battery power. A trill sound following a
decode attempt.
Indicates
Correct configuration bar code scanned or
correct sequence performed.
Exited configuration mode without changing
parameter setting.
Input error. Possible causes are:
Incorrect bar code scanned.
Incorrect sequence of bar codes scanned.
Cancel scanned.
Remain in configuration mode.