Rear View - Mitsubishi Electric DX-TL5000E Installer Manual

Major operations and their functions (continued)
Rear view (continued)
13. ALARM IN terminals
Input terminals for alarm signal.
ALARM OUT terminals
Output terminals for alarm signal.
14. RESET button
Used to reset the unit and turn off the power. At this
time, picture data, menu settings, and the present
time are kept.
15. I/O terminals
CLOCK ADJ terminal
Input terminal to set the present time. Time display
is adjusted to the nearest hour (00 minutes 00 sec-
onds) when this terminal receives the CLOCK ADJ
signal.
• The on-screen clock is reset to the nearest hour by
applying a signal to the CLOCK ADJ terminal. For
example, if the current time is 11:29:59, it will be
reset to 11:00:00, and if the current time is 11:30:00,
it will be reset to 12:00:00.
CLOCK ADJ OUT terminal
Output terminal to send the signal to the other
recorders connected for adjusting the clock to the
nearest hour (00 minutes 00 seconds).
REC terminal
Input terminal to start recording. This terminal is not
available during timer recording.
REC STOP terminal
Input terminal to stop recording. This terminal is not
available during timer recording.
EMERGENCY terminal
Input terminal to start EMERGENCY recording
compulsorily.
•••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• Beginning
14
IN
1 2
OUT
IN
9 10
OUT
CLAMPER
~
AC IN
MAIN
100-240V
OFF ON
1 2
3 4
VIDEO VIDEO
3 4 5 6 7 8
Y/C
CAMERA OUTPUT A OUTPUT B
OUT IN
11 12 13 14 15 16
VIDEO CASCADE
SERIAL BUS
RESET
ALARM OUT ALARM IN
GND
RS-232C
11 13 14
12
MODE OUT 1 to MODE OUT 4 terminals
Output terminal to indicate the current mode of this
unit. Select the mode of the unit to be output in the
<Mode Out Settings> (Setup Menu System Rear
Terminal Setting Mode Out Settings).
CALL OUT terminals/CALL OUT GND terminal
This is the ISOLATION output terminal. Information
to be transmitted externally consists of CALL OUT
settings made in the <Call Out Settings> (Setup
Menu System Rear Terminal Setting Call Out
Settings) as well as fixed output settings.
DC 12 V OUT terminal
Output the signal only when both the MAIN switch
and POWER button are turned ON. The maximum
electric current is 350 mA.
16. RS485 IN/OUT connectors
Connectors for the remotely control of the recorders.
Used to connect with the other recorders.
17. RS422/RS232C connectors
Connectors for camera operations such as pan, tilt,
and zoom when these connectors are connected to
the dome camera.
5 6 8 9 10
7
AUDIO IN
1
2
OPTION SLOT
3 4
OUT IN
CLAMPER
AUDIO CASCADE
AUDIO OUT
SERIAL BUS
LAN-A LAN-B
100 10 100 10
STORAGE COM
P T Z
RS485 RS485
OUT IN
15 16 17