Setup Wizard - Mitsubishi Electric DX-TL5000E Installer Manual

Setup Wizard

Setup Wizard
Setup wizard is displayed, in order to set up an indispen-
sable function, when this unit is turned on for the first time.
• Only when the unit is turned on for the first time, the
setup wizard screen is displayed automatically. It is
not displayed next time.
Turn on the power for the first time
Select whether or not to use Setup Wizard
Language Selection
D
D Time Date Adjust
D Day Light Saving
D HDD Connection
HDD Selection
2
Detailed setting (Internal HDD)
1
2 Detailed setting (serial bus HDD)
3 Detailed setting (SCSI HDD)
HDD Configuration
D
2 Partition setting
Select whether or not to set normal recording conditions
D
Recording setting (step 1 Camera check)
D
Recording setting
D
(step 2 Define regular recording cycle)
Recording setting
C
(step 3 Confirm recording settings for each camera)
5 Camera settings overview
Finish
E
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
28
1. After connecting the cameras and the monitors, turn
step
on the MAIN switch on the rear panel and wait until
the ACCESS indicator is turned off, then press the
POWER button on the front panel.
• The <Setup Wizard> screen appears.
• The POWER button does not operate while the
ACCESS indicator is flashing. Press the POWER
button after the indicator is turned off and "POWER
OFF" is displayed on the LCD display on the front
panel.
2
step
2. Select whether or not to use the setup wizard.
step
• Select "Go" when you want to use the setup
3
step
wizard. If not, select "Quit." When selecting "Quit,"
the clock start running from the initial setting.
4
step
• Beware that the menu screen cannot be exited while
setting the setup wizard. Furthermore the screen
which has been already set cannot be displayed again
depending on the menu.
5-1
3. (When selecting "Go")
step
step
Select the desired language.
• The <Language Selection> screen appears. The
5-2
step
language of the menu can be selected in this
screen.
• Select the desired language and then select
"Execute" when you have changed the setting.
The unit restarts when selecting "Execute."
• Select "Next" when the language setting does not
have to be changed.
4. Set the present time and daylight saving setting. See
step
page 55 for the details.
6-1 • Select "Next" when the setting is completed.
step
6-2
• The clock start running when exiting this screen.
step
5 . Set the connected HDD.
step
-1
7 • Select "Next" when only the internal HDDs are
step
used.
• When the external HDDs are used, select
8
"Setting" and set the detailed setting for each HDD
step
connected.
5 . (When selecting "Setting")
9 step
-2
step
Make the detailed setting for internal, serial bus, and
SCSI HDDs.
• In the detailed setting screen, select "Add" to use
10
the selected HDD as the main device. Select
step
"Remove" when the selected HDD is not used as
the main device.
• When the setting is completed, return to the
screen of step 5-1 and then select "Next."
11
step