Monitor Output Adjust; On Screen Display Setting; Audio Setting; Reset To Factory Setting - Mitsubishi Electric DX-TL5000E Installer Manual

System (continued)

Monitor Output Adjust

This item is used to adjust the monitor output.
Setup Menu
System
4

6 On Screen Display Setting

5 Monitor Output Adjust
1. Adjust the monitor scan mode.
step
• Adjust the display range of the monitor. Set it
depending on the displaying area of the monitor.
Overscan: Displays overscaned picture. Generally,
this setting is suitable for the monitor of which the
display range is narrow such as a television for
domestic use.
Underscan: Displays underscaned picture.
Generally, this setting is suitable for the monitor of
which the display range is wide such as a liquid
crystal television.
2. Adjust the alpha blend level.
step
• The picture supplied from the camera can be
viewed through the menu screen being displayed.
2-1 Menu
• Adjust the see-through level of the menu display.
2-2 On Screen Information
• Adjust the see-through level of the information
such as the clock or title.

Audio Setting

This item is used to set the audio output for each camera
number connected. This setting can be made for the single
screen display and the split screen display individually.
• Audio setting is available only when the optional audio
interface board DX-SC5 is attached to this unit.
Setup Menu
System
4
Audio Setting
7
1 Single Display
2
Multiplex Display
1. Select the desired audio output for each camera
step
number and split screen.
• This setting is valid for the audio output during
playback or displaying a picture from a camera.
Channel 1: During displaying the picture from a
camera, outputs audio from the AUDIO IN 1
terminal. During playback, outputs the audio
recorded from the AUDIO IN 1 terminal.
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
66
Channel 2: During displaying the picture from a
camera, outputs audio from the AUDIO IN 2
terminal. During playback, outputs the audio
recorded from the AUDIO IN 2 terminal.
Channel 3: During displaying the picture from a
camera, outputs audio from the AUDIO IN 3
terminal. During playback, outputs the audio
recorded from the AUDIO IN 3 terminal.
Channel 4: During displaying the picture from a
camera, outputs audio from the AUDIO IN 4
terminal. During playback, outputs the audio
recorded from the AUDIO IN 4 terminal.
Off: Does not output audio.
• The audio can be switched temporarily by using
<Audio> (User Menu Audio). (

Reset to Factory Setting

This item is used to reset the menu settings.
Setup Menu
System
4
Reset to Factory Setting
8
1. Select "Execute" to initialize menu settings.
step
• The setting of present time, password, "E-mail
Address" and "Recorder ID" of LAN B are not reset.
• When you execute <Reset to Factory Setting> with
the setting of "IP Address," "Sub Net Mask,"
"Gateway," "Service Port Setting" of LAN B, "IP
Address," "Sub Net Mask," "Gateway" of LAN A, or
menu language selection changed, the power turns
off and the unit restarts.
Setup Menu
See page 44.)