Alarm Recording Connection - Mitsubishi Electric DX-TL5000E Installer Manual

Alarm recording connection

The diagram below shows an example of connection for alarm signals corresponding to sensor number 1.
EMERGENCY/ALARM IN/REC/
CLOCK ADJ Input terminal
• Input Circuit
10kΩ
22kΩ
Input
terminal
GND
<Interface circuit inside the unit>
CALL OUT Output terminal
• Output Circuit
<Interface circuit inside the unit>
•••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• Connections
GND
RS-232C
5V
0.047µF
5V
4.7kΩ
Mode out +/– (1-4)
Relay output
Call out +/–
Photo coupler output Non active: Open.
CALL OUT terminal
Emergency input/Alarm input (1-16)/Recording/Clock adjust input
CALL OUT GND terminal
Alarm Output
ALARM OUT
ALARM SWITCH
ALARM OUT Output terminal
• Output Circuit
Output terminal
GND terminal
<Interface circuit inside the unit>
Active:
Non active: Open.
Active:
Active:
Non active: Open.
Active:
Non active: Open.
ALARM IN
MODE OUT 1 - 4 Output terminal
• Output Circuit
<Interface circuit inside the unit>
Short Max. Drive current 500 mA DC.
Max. Voltage +24 V DC.
Short Max. Drive current 7 mA DC.
Max. Voltage +24 V DC.
When terminals are short-circuited or "Low"
Level is applied.
"Low Level" Max. Drive current 7 mA DC.
Max. Voltage +24 V DC.
MODE OUT
17