System Menu; Com/Lan; Rs-232C Setting; Rs-485 Cascade Setting - Mitsubishi Electric DX-TL5000E Installer Manual

COM/LAN

This menu is used to set the communication settings be-
tween this unit and the external device connected.

RS-232C Setting

This item is used to remotely control this unit via a PC con-
nected to the RS-232C terminal.

System Menu

1 COM/LAN
RS-232C Setting
1
1. Select the communication mode.
step
Remote A: Controls this unit via a PC and this unit
returns every status information.
Remote B: Controls this unit via a PC and this unit
returns only the response to the command code.
Remote C: Controls this unit via a PC and this unit
returns nothing.
Off: Does not control this unit via a PC.
2. Set the port settings shown below.
step
• Transmission mode
• Data bit length
• Parity bit
• Stop bit length
• Delimiter
• Set all the settings to the same values as the PC
connected.

RS-485 Cascade Setting

This item is used to make the settings for the cascade
function using the recorders connected via the RS-485
terminal.
System Menu
1 COM/LAN
2 RS-485 Cascade Setting
1. Select the cascade connection mode of this unit.
step
Standalone: Does not perform the cascade
function.
Cascade: Performs the cascade function.
2. Select the recorder address.
step
Master ID:01: Sets this unit as the master recorder
for the cascade function.
Slave ID:02 to 16: Sets this unit as the slave
recorder for the cascade function.
• "Recorder Address" displays only when the "Cascade
Connection Mode" is set to "Cascade."
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
68

LAN B (Communication) Setting

This item is used to make the communication settings between
this unit and the PC connected via LAN B.
System Menu
1 COM/LAN
3
LAN B (Communication) Setting
1
LAN B Address Setting
2 Service Port Setting
3 E-mail Notification Information
D
E-mail Notification Detailed Infomation
4
IP Alarm Notification Information
D
Alarm Notification Detailed Infomation
1. Set the IP address, sub net mask, and Gateway.
step
• MAC address is shown on the bottom of the
screen of <LAN B (Communication) Setting>.
• Do not assign the same IP address or network address
for LAN A and LAN B.
• Do not assign "000.000.000.000" to IP address and
broadcast address. If this address is assigned,
communications or any other functions of this unit may
not be performed correctly.
• The setting cannot be changed during recording. Stop
recording before changing the setting.
2. Set the port setting of "Web," "User Access," and
step
"Administrator."
• This item is used to set the port number in order
to connect a PC.
• Normally, leave the setting as is.
• Do not change the setting without sufficient knowledge
about the network setting.
• When making the settings other than the port settings
of "Web," "User Access," and "Administrator," using
the specified application is required. Consult your
dealer about the specified application.
3. Check the settings of "E-Mail Address" and
step
"Recorder ID."
• When selecting "Mail," the e-mail is sent for the
selected address.
System Menu
7
step
1
step
2
step
3
step
4
step
5
step
6
step