Cisco SF500-24 Administration Manual page 368

Configuring DHCP
DHCP GUI
STEP 1
STEP 2
STEP 3
STEP 4
STEP 1
STEP 2
STEP 3
Cisco 500 Series Stackable Managed Switch Administration Guide
Defining DHCP Interface Settings
In Layer 2, DHCP Relay and Snooping can only be enabled on VLANs with IP
addresses.
In Layer 3, DHCP Relay and Snooping can be enabled on any interface with an IP
address and on VLANs with or without an IP address.
To enable DHCP Snooping/Relay on specific interfaces:
Click IP Configuration > DHCP > Interface Settings. The
displayed.
To enable DHCP Relay or DHCP Snooping on an interface, click ADD.
Select the interface and the features to be enabled.
Click Apply. The settings are written to the Running Configuration file.
Defining DHCP Snooping Interfaces Settings
Packets from untrusted ports/LAGs are checked against the DHCP Snooping
Binding database (see the DHCP Snooping Binding Database page).
By default, interfaces are trusted.
To designate an interface as untrusted:
Click IP Configuration > DHCP > DHCP Snooping Trusted Interfaces. The
Snooping Trusted Interfaces
Select the interface and click Edit. The Edit Interface Settings page is displayed.
Select Trusted Interface (Yes or No) and click Apply to save the settings to the
Running Configuration file.
Defining DHCP Snooping Binding Database
See How the DHCP Snooping Binding Database is Built
dynamic entries are added to the DHCP Snooping Binding database.
Note the following points about maintenance of the DHCP Snooping Binding
database:
page is displayed.
19
Interface Settings
page is
DHCP
for a description of how
359