Defining Snmpv3 Notification Recipients - Cisco SF500-24 Administration Manual

Configuring SNMP
Notification Recipients
STEP 4
STEP 1
STEP 2
STEP 3
Cisco 500 Series Stackable Managed Switch Administration Guide
• Link Local Interface—If the IPv6 address type is Link Local, select whether
it is received through a VLAN or ISATAP.
• Recipient IP Address—Enter the IP address of where the traps are sent.
• UDP Port—Enter the UDP port used for notifications on the recipient device.
• Notification Type—Select whether to send Traps or Informs. If both are
required, two recipients must be created.
• Timeout—Enter the number of seconds the device waits before re-sending
informs.
• Retries—Enter the number of times that the device resends an inform
request.
• Community String—Select from the pull-down the community string of the
trap manager. Community String names are generated from those listed in
the Community page.
• Notification Version—Select the trap SNMP version.
Either SNMPv1 or SNMPv2 may be used as the version of traps, with only a
single version enabled at a time.
• Notification Filter—Select to enable filtering the type of SNMP notifications
sent to the management station. The filters are created in the Notification
Filter page.
• Filter Name—Select the SNMP filter that defines the information contained
in traps (defined in the Notification Filter page).
Click Apply. The SNMP Notification Recipient settings are written to the Running
Configuration file.

Defining SNMPv3 Notification Recipients

To define a recipient in SNMPv3:
Click SNMP > Notification Recipients SNMPv3. The
SNMPv3
page is displayed.
This page displays recipients for SNMPv3.
Add SNMP Notification Recipient
Click Add. The
Enter the parameters.
Notification Recipients
page is displayed.
22
420