Connecting By Using Telnet - Cisco SF500-24 Administration Manual

Console Menu Interface

Connecting By Using Telnet

Connecting By Using Telnet
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
NOTE
STEP 7
Cisco 500 Series Stackable Managed Switch Administration Guide
Telnet is disabled by default. It must be enabled by using the web-based switch
configuration utility or the console interface and a serial cable connection. The
procedure for enabling Telnet by using the console interface is described in the
Telnet Configuration
To open the console interface by running Telnet in the Windows command-line:
Select Start > Run.
Enter CMD in the Open field and press Enter.
Type telnet, a space, and the switch IP address. For example:
c:\>telnet 192. 1 68. 1 . 1 14
Press Enter.
Enter username/password. The default username and password is cisco/cisco.
Enter the command debug-mode, then press Enter, then enter the command
menu. The Login displays. Press Ctrl-R to refresh the Menu CLI Login or to jump
to the Menu CLI Login from any other window.
If this is the first time you have logged in or the switch has been reset to factory
defaults, you are asked to change your password. The Change User Password is
displayed. Use these options to create and save a new password.
Otherwise, the Switch Main Menu displays.
Continue to the Console Interface Main Menu
section.
section.
25
452