Cisco SF500-24 Administration Manual page 387

Configuring Quality of Service
QoS Features and Components
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
STEP 8
Cisco 500 Series Stackable Managed Switch Administration Guide
Assign the schedule method (Strict Priority or WRR) and bandwidth allocation for
WRR to the egress queues by using the
Designate an egress queue to each IP DSCP/TC value with the
page. If the switch is in DSCP trusted mode, incoming packets are put into the
egress queues based on the their DSCP/TC value.
Designate an egress queue to each CoS/802. 1 p priority. If the switch is in CoS/
802. 1 trusted mode, all incoming packets will be put into the designated egress
queues according to the CoS/802. 1 p priority in the packets. This is done by using
CoS/802. 1 p to Queue
the
If required for Layer 3 traffic only, assign a queue to each DSCP/TC value, by using
DSCP to Queue
the page.
Enter bandwidth and rate limits in the following pages:
a. Set egress shaping per queue by using the Egress Shaping Per Queue page.
b. Set ingress rate limit and egress shaping rate per port by using the Bandwidth
page.
c. Set VLAN ingress rate limit by using the VLAN Ingress Rate Limit page.
Configure the selected mode by performing one of the following:
a. Configure Basic mode, as described in Workflow to Configure Basic QoS
Mode
b. Configure Advanced mode, as described in Workflow to Configure
Advanced QoS Mode.
Queue
page.
page.
DSCP to Queue
21
378