Cisco SF500-24 Administration Manual page 287

Configuring IP Information
Management and IP Interfaces
STEP 1
Cisco 500 Series Stackable Managed Switch Administration Guide
To configure the IPv4 addresses:
Click IP Configuration > Management and IP Interface > IPv4 Interface. The
IPv4 Interface page opens.
For SG500X devices only, to enable IPv4 routing, check the Enable box. In Sx500
devices, when you change the system mode from Layer 2 to Layer 3 it
automatically enables IP routing.
This page displays the following fields in the IPv4 Interface Table:
• Interface—Interface for which the IP address is defined.
• IP Address Type—IP address defined as static or DHCP.
- Static—Entered manually.
- DHCP—Received from DHCP server.
• IP Address—Configured IP address for the interface.
• Mask—Configured IP address mask.
• Status—Results of the IP address duplication check.
- Tentative—There is no final result for the IP address duplication check.
- Valid—The IP address collision check was completed, and no IP address
collision was detected.
- Valid-Duplicated—The IP address duplication check was completed,
and a duplicate IP address was detected.
- Duplicated—A duplicated IP address was detected for the default IP
address.
- Delayed—The assignment of the IP address is delayed for 60 second if
DHCP Client is enabled on startup in order to give time to discover DHCP
address.
- Not Received—Relevant for DHCP Address. When a DCHP Client starts
a discovery process, it assigns a dummy IP address 0.0.0.0 before the
real address is obtained. This dummy address has the status of "Not
Received".
17
278