Viewing Etherlike Statistics - Cisco SF500-24 Administration Manual

Viewing Statistics

Viewing Etherlike Statistics

Viewing Etherlike Statistics
STEP 1
STEP 2
Cisco 500 Series Stackable Managed Switch Administration Guide
The Etherlike page displays statistics per port according to the Etherlike MIB
standard definition. The refresh rate of the information can be selected. This page
provides more detailed information regarding errors in the physical layer (Layer 1),
which might disrupt traffic.
To view Etherlike Statistics and/or set the refresh rate:
Click Status and Statistics > Etherlike. The Etherlike page is displayed.
Enter the parameters.
• Interface—Select the type of interface and specific interface for which
Ethernet statistics are to be displayed.
• Refresh Rate—Select the amount of time that passes before the Etherlike
statistics are refreshed.
The fields are displayed for the selected interface.
• Frame Check Sequence (FCS) Errors—Received frames that failed the
CRC (cyclic redundancy checks).
• Single Collision Frames—The number of frames involved in a single
collision, but were successfully transmitted.
• Late Collisions—Collisions that have been detected after the first 512 bits
of data.
• Excessive Collisions—Number of transmissions due to excessive collisions.
• Oversize Packets—Packets greater than 1518 octets received.
• Internal MAC Receive Errors—Frames rejected because of receiver errors.
• Pause Frames Received—Received flow control pause frames.
• Pause Frames Transmitted—Flow control pause frames transmitted from
the selected interface.
To clear statistics counters:
• Click Clear Interface Counters to clear the selected interface's counters.
• Click Clear All Interface Counters to clear the counters of all interfaces.
2
13