Vibration Module - HP Split 13 x2 PC Maintenance And Service Manual

Vibration module

Description
Vibration module
Before removing the vibrating motor, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Disconnect the tablet from the keyboard dock (see
on page
5. Remove the following components:
● Display rear cover (see
● Fan (see
● Heat sink (see
●
WLAN module (see
● Display cable (see
● Touchscreen board cable (see
●
Volume board cable (see
● Bottom trim (see
● Audio board (see
● Card reader cable (see
●
Speakers (see
● Battery (see
● Frame (see
Remove the vibration module from the display:
Locate the vibration module on the side of the tablet, and then remove the vibrating motor .
▲
74 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
32).
Display rear cover on page
Fan on page 48)
Heat sink on page
WLAN/Bluetooth combo card on page
Display cable on page
Volume board on page
Bottom trim on page
Audio board on page
Card reader on page
Speakers on page
Battery on page
Frame on page 69)
Releasing the tablet from the keyboard dock
45)
49)
56)
Touchscreen board on page
59)
61)
64)
66)
67)
68)
Spare part number
732272-001
51)
58)