Hinge Assembly - HP Split 13 x2 PC Maintenance And Service Manual

Hinge assembly

Description
Hinge assembly
Before removing the hinge, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Disconnect the tablet from the keyboard dock (see
on page
5. Remove the base enclosure (see
6. Disconnect the battery cable.
Remove the hinge assembly:
1. Remove the four Phillips PM2.5×5.0 screws (1) that secure the hinge to the dock.
2. Disconnect the cables from each side of the dock (2).
NOTE:
cable. The board is not secured at this point in the disassembly process.
36 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
32).
Base enclosure on page
When disconnecting the cable from the HDMI board, hold the board in place to disconnect the
Releasing the tablet from the keyboard dock
33.
Spare part number
732280-001