Touchpad Board - HP Split 13 x2 PC Maintenance And Service Manual

Touchpad board

Description
TouchPad board (includes cable)
Before removing the TouchPad board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Disconnect the tablet from the keyboard dock (see
on page
5. Remove the base enclosure (see
6. Remove the battery (see
7. Remove the hinge assembly (see
Remove the TouchPad board and cable:
1. Remove the two Phillips broadhead PM2.0×2.0 screws (1) that secure the touchpad board to the dock.
2. From the inside of the dock, push downward on the board to disengage it from the dock, and then
remove it from the dock (2).
Reverse this procedure to install the TouchPad board.
42 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
32).
Base enclosure on page
Battery on page
Releasing the tablet from the keyboard dock
33.
37.
Hinge assembly on page 36.
Spare part number
732278-001