Power Connector - HP Split 13 x2 PC Maintenance And Service Manual

Power connector

Description
Power connector
Before removing the power connector, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Disconnect the tablet from the keyboard dock (see
on page
5. Remove the base enclosure (see
6. Remove the battery (see
7. Remove the hinge assembly (see
Remove the power connector:
1. Remove the Phillips PM2.5×5.0 screw (1) that secures the power connector bracket to the dock.
2. Lift the bracket up and out of the dock (2).
3. Remove the power connector (3) from the dock.
Reverse this procedure to install the power connector.
32).
Battery on page
Releasing the tablet from the keyboard dock
Base enclosure on page
37.
Hinge assembly on page
Spare part number
732288-001
33.
36.
Dock components 43