Card Reader - HP Split 13 x2 PC Maintenance And Service Manual

Card reader

Description
Card reader (includes cable)
Before removing the card reader, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Disconnect the tablet from the keyboard dock (see
on page
5. Remove the display rear cover (see
6. Disconnect the battery cable (see
7. Remove the bottom trim (see
8. Remove the audio board (see
Remove the card reader:
1. Disconnect the card reader cable (1) from the system board.
2. Remove the two Phillips PM2.0×4.0 screws (2) that secure the card reader to the tablet.
3. Lift the card reader from the tablet (3).
Reverse these procedures to install the card reader.
66 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
32).
Bottom trim on page
Audio board on page
Releasing the tablet from the keyboard dock
Display rear cover on page
Battery cable on page 46).
61).
64).
Spare part number
732283-001
45).