Wlan Module - HP ENVY x360 Convertible Maintenance And Service Manual

WLAN module

Description
Broadcom BCM43142 802.11 b/g/n 1x1 Wi-Fi + BT4.0 M.2 Combo Adapter
Realtek RTL8723BE 802.11b/g/n 1x1 Wi-Fi + BT4.0 Combo Adapter
CAUTION:
authorized for use in the computer by the governmental agency that regulates wireless devices in your
country or region. If you replace the module and then receive a warning message, remove the module to
restore device functionality, and then contact technical support.
Before removing the WLAN module, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the top cover (see
Remove the WLAN module:
1. Position the system board upright.
2. Remove the Phillips PM2.0×3.0 screw (1) that secures the module to the system board, and then pull the
module out from the socket (2).
Reverse this procedure to install the WLAN module.
34 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
To prevent an unresponsive system, replace the wireless module only with a wireless module
Top cover on page 27).
Spare part number
756751-005
792610-005