Wlan Module - HP ELITE x2 1012 G1 Maintenance And Service Manual

WLAN module

IMPORTANT:
and replacement.
Description
WLAN module
WIGIG Module W/Bracket W/Cable
11ac 2x2 INT 8260NGW SnfP2
11ac 2x2 INT 8260NGW SnfP2NV
INT 802.11AC 18260+BT4 2x2
WLAN antenna
Before removing the WLAN module, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Keyboard (select products only) (see
b. Back cover (see
c. Display panel (see
d. Touch controller board (see
Remove the WLAN module:
Remove 1 Phillips M2.0x2.0 screw (1), disconnect the 2 cables (2), slide the WLAN module to the right,
▲
and then remove it (3).
34 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
Make special note of each screw and screw lock size and location during removal
Back cover on page
Display panel on page
Touch controller board on page
Keyboard (select products only) on page
30)
31)
33)
Spare part number
844884-001
806721-001
806722-001
810814-005
844869-001
29)