Power In Connection - ADDER AdderView CATxIP 1000 User Manual

Power in connection

The.AdderView.CATxIP.1000.unit.is.supplied.
with.a.standard.5V.power.adapter..There.is.no.
on/off.switch.on.the.unit,.so.operation.begins.
as.soon.as.a.power.adapter.is.connected.
To connect the power supply
1. Attach.the.output.lead.from.the.power.adapter.to.the.
panel.of.the.AdderView.CATxIP.1000.
output lead from
power adapter
LOCAL GLOBAL
USER USER
IP
POWER
IN
CAM
COMPUTER POWER
SYSTEM SWITCH
.socket.on.the.rear.
5V
AdderView CATxIP
000 rear panel
O P
T I O
N S
5 V
2 . 0
1 6
A
1
1 2
C O
1
M P
U T
2. Connect.the.IEC.connector.of.the.supplied.country-specific.power.lead.to.
the.socket.of.the.power.adapter.
3. Connect.the.power.lead.to.a.nearby.main.supply.socket.
Note: Both the AdderView CATxIP 1000 and its power supply generate heat
when in operation and will become warm to the touch. Do not enclose them
or place them locations where air cannot circulate to cool the equipment. Do
not operate the equipment in ambient temperatures exceeding 40 degrees
Centigrade. Do not place the products in contact with equipment whose surface
temperature exceeds 40 degrees Centigrade.