Host Configuration - ADDER AdderView CATxIP 1000 User Manual

Host configuration

This.page.provides.the.opportunity.to.configure.various.details.for.each.of.the.
host.systems.that.may.be.connected.to.the.AdderView.CATxIP.1000..Each.entry.
can.be.configured.with.a.name,.the.permitted.users,.the.hot.key.combinations.
required.to.switch.to.it.and,.if.required,.appropriate.power.control.commands.
Add entry for unrecognised host
. When.selected,.any.systems.visited.that.are.not.specified.in.the.Hosts.list,.will.
be.added.to.the.list..It.is.useful.to.tick.this.option.when.cascaded.systems.are.
first.added.to.the.installation.
Erase Host Configuration
. Removes.all.hosts.from.the.list..
To get here
1. Using.VNC.viewer.or.a.browser,.log.on.as.the.'admin'.user.
2. Click.the.'Configure'.button.in.the.top.right.corner.
3. Click.the.'Host.Configuration'.option.
To create a new host entry
1. Click.one.of.the.host.entries.to.reveal.a.Host.configuration.dialog..
. Note: Host computers connected to a cascaded AdderView unit will appear
within the list (providing the 'Add entry for unrecognised host' option is
ticked) and you can easily discern them from directly connected systems
because their addresses will be four digits, rather than two...
Name
. Enter.the.name.that.will.be.displayed.in.the.viewer.window.when.you.
click.the.Host.button.
Users
. Select.the.users.that.will.be.permitted.to.connect.to.this.host..Either.
enter. .to.allow.all.users.or.a.list.of.users.separated.by.commas.(e.g..
*
admin,.nigel,.preben,.steve).
Hotkey / KVM Port
. Declare.the.numeric.sequence.that.is.pressed.together.with.the.hotkeys.
(usually.Ctrl.+.Alt).to.select.this.host.system,.which.is.the.same.value.as.
the.KVM.port.number..
Power On
. Enter.the.code.required.to.make.an.attached.power.control.unit.apply.
power.to.the.selected.host..See.Power switching
details..
Power Off
. Enter.the.code.required.to.make.an.attached.power.control.unit.remove.
power.from.the.selected.host..See.Power switching
details.
2. Enter.the.required.information.in.each.field.
3. Click.the.OK.button.
configuration.for.
configuration.for.