Power In Connection; Optional Rc4 Remote Control - ADDER AV4PRO-VGA User Manual

Power in connection

The AdderView PRO unit is supplied with either a 12.5W (single screen version)
or 20W (Multiscreen versions) power adapter. There is no on/off switch on the
unit, so operation begins as soon as a power adapter is connected.
To connect the power supply
1 Attach the output lead from the power
adapter to the socket on the rear panel
5V
of the unit.
2 Connect the IEC connector of the supplied country-specific power lead to
the socket of the power adapter.
3 Connect the power lead to a nearby main supply socket.
Note: Both the unit and its power supply generate heat when in operation and
will become warm to the touch. Do not enclose them or place them in locations
where air cannot circulate to cool the equipment. Do not operate the equipment
in ambient temperatures exceeding 40 degrees Centigrade. Do not place the
products in contact with equipment whose surface temperature exceeds 40
degrees Centigrade.

Optional RC4 remote control

The optional RC4 remote control unit (full part number: RC4-8P8C) can be used
to provide direct push button access to any channel from your desktop. The
RC4 remote control is supplied with a 3 metre cable that is used to link with the
OPTIONS
To connect the remote control
1 Connect either end of the supplied cable to the socket at the rear of the
IN D
O O
U S R
E
O N
L Y
5 V
2 .5
A
U S
E R
C O
N S
O L
E
4
O P
T I O
N S
2 Connect the other end of the cable to the
port on the rear panel of the unit.
RC4 remote control.
the unit.
U S
E R
C O
N S
O L
E
O P
T I O
port on the rear panel of
OPTIONS
4
N S
9