Power Supply Connection - ADDER AdderView Matrix User Manual

Power supply connection

The AdderView Matrix is supplied with a single power supply and an appropriate
country-specific IEC power lead. The AdderView Matrix does not have an on/off
switch so operation begins as soon as the power supply is connected.
Note: When computers are first powered on they communicate with any
attached keyboards and mice in order to setup parameters required by their
operating system. It is necessary for the AdderView Matrix to be attached and
powered on during this sequence so that it can give the required responses
and keep track of all modes and settings requested by each of the connected
computers.
To connect the power supply
1 Connect the low voltage output connector from the power supply unit to
the AdderView Matrix power socket in the lower left corner of the rear
panel.
5 V
2 A
2 Connect the IEC connector of the supplied country-specific power lead to
the socket of the power supply.
3 Connect the power lead to a nearby mains supply socket.
9